Lanner FW-8892 - Manual (Page 43)

FW-8892
43
Remote Access Configuration:
Press to enter the sub-menu and enable Remote Access then the following
screen appears:
Serial port number:
Select Serial Port for console redirection.
Serial Port Mode:
Select Serial Port setting.
Flow Control:
Select Flow Control for console redirection.
Redirection After BIOS POST:
DISABLE, Turns off the redirection after POST. Boot Loader, Redirection is active
during POST and during Boot Loader. Always, Redirection is always active.
Terminal Type:
Select the target terminal type.
VT-UTF8 Combo Key Support:
Enable VT-UTF8 Combination Key Support for ANSI/VT100 terminals.
Sredir Memory Display Delay:
Gives the delay in seconds to display memory information.