Lanner FW-8892 - Manual (Page 28)

FW-8892
28
Installing the outer rails to the rack:
Use the following procedures to install the outer rail:
1. Attach the rail to the posts of the rack by using three rack screws.
2. Extend the outer back rail to the back of the rack and firmly tighten it
with two rack screws.
3. Repeat step 1 and 2 above to install the other rail.
Installing the system to the rack:
Holding the system with its front facing you, lift the chassis and carefully
insert the system by sliding the inner rail into the outer rail. Push the chassis
all the way toward the back until the front brackets contact the rack. You
may also fix the front brackets to the rack if the system doesn’t require
frequent pulling out of the rack.