Lanner FW-8756 - Manual (Page 9)

6
Introduction
Chapter 2
Network Application Platforms
Installing a CompactFlash Card
FW-8756 provides one CompactFlash slot. Follow the
procedures bellow for installing a CompactFlash card.
Align CompactFlash card and the card slot with the 1.
arrow pointing toward the connector.
Push the card to insert into the connector.
2.
CPU and the Heat Sink Installation
The FW-8756 sever system is powered by the MB-8756
sever board, which comes with one ZIF type LGA775 CPU
socket.
Follow the procedures bellow for installing a CPU
Remove the CPU socket cap. 1.
Press the load lever and release it from the retention 2.
tab.
Lift the load lever and then the plate.
3.
Align the cut-out of the CPU and the notch on the 4.
socket. The CPU should fit perfectly into the socket.
Note that the CPU fits in the socket in only one
direction.
Close the plate and push the load lever to lock it back
5.
to the retention tab.
Peel off the sticker on the CPU to expose the thermal
6.
compound.
Put the heat sink on top of the installed CPU, and match
7.
the screws with the screw holes on the board. Fasten
two screws which are opposite to each other at a time
and then the other two. It is easier this way because of
the springiness of the bracket.
Place the heat sink cover on top of the installed heat
8.
sink and screw the three screws to fasten it on the
case.
1
2
4
5
3
3.5” HDD installation
( screw slots are on the
bottom of the tray)
3.5” HDD installation