Riser card installation, Front ethernet module installation, Chapter 2 – Lanner FW-8756 User Manual
Page 10: Introduction
7
Introduction
Chapter 2
Network Application Platforms
Align the riser card with the PCI-E golden finger
1.
connector.
Insert the card into the connector firmly.
2.
Fasten the screws to fix the card onto the board.
3.
Riser Card Installation
3
2
Front Ethernet Module Installation
To install the front Ethernet module, take off the front
1.
bezel first by unfastening the threaded screws at the
bottom of the case.
Insert the Ethernet module into the front expansion
2.
slot. You should hear a click when the module connects
to the riser card.
Fasten the screw back on the bottom of the case to
3.
secure the module on the system.
Note:
The CPU heat sink can only be installed in only
1.
one orientation as shown in the picture.
To protect the CPU socket pins, retain the CPU
2.
cap when the CPU is not installed.
2
3
5
4
1
7
8
- LVC-2000 (39 pages)
- LVC-5000(N4) (42 pages)
- LVC-5550S (41 pages)
- LVC-5570 (48 pages)
- LVC-5770 (49 pages)
- FW-6432 (16 pages)
- FW-7525 (41 pages)
- FW-5330 (38 pages)
- FW-6486 (18 pages)
- FW-6436 (19 pages)
- FW-7573 (44 pages)
- FW-7568 (52 pages)
- FW-7540 (47 pages)
- FW-8759 (47 pages)
- FW-7581 (23 pages)
- FW-8758 (42 pages)
- FW-7610 (44 pages)
- FW-7575 (48 pages)
- FW-8760 (53 pages)
- FW-8877 (46 pages)
- FW-8892 (58 pages)
- FW-8893C (49 pages)
- FX-3411 (48 pages)
- FW-8894 (31 pages)
- FW-8771 (47 pages)
- RS12-38800 (64 pages)
- MR-320 (20 pages)
- FX-3210 (54 pages)
- MR-301 (16 pages)
- MR-350 (12 pages)
- MR-330A (16 pages)
- MR-730 (18 pages)
- VES-220 (19 pages)
- VES-270 (19 pages)
- VES-310 (15 pages)
- VES-310 V2 (20 pages)
- VES-500 (21 pages)
- EM-F345 (30 pages)
- VES-8X2 (16 pages)
- VES-8X6 (17 pages)
- LEC-2026 (67 pages)
- LEC-2010 (65 pages)
- LEC-2136 (20 pages)
- LEC-2050 (38 pages)