KACO XP10U-H4 - Manual (Page 14)

C o n f i g u r a t i o n a n d O p e r a t i o n
Page 14 Operator Instructions blueplanet XP10U H4 / H6 and XP10U H4 / H6 PSD
Menu
level
Display/settings Action in this menu/meaning
0 1 2 3 1 Date & time
 Set the time and date.
NOTICE: For self-diagnostic purposes, the inverter carries out a daily
restart at midnight. To avoid having a restart occur during feed-in
operation and to always obtain reliable log data, ensure that the time is
correctly set.
0 1 2 3 1 Ethernet
 Assign a unique IP address.
 Assign a subnet mask.
 Assign a gateway.
0 1 2 3 1 Webserver  Activate or deactivate the integrated webserver.
0 1 2 3 0 “Parameters” menu
 Press the right arrow key or the OK key.
NOTICE: The inverter does not display the “Parameters” menu in the
standard confi guration. To display the menu:
1. Open the menu.
2. Simultaneously hold down the up and down keys for several
seconds.
0 1 2 3 1 Country
1. Input the four-character password via the 4-way key. The password
is unit-specifi c.
2. Confi rm the entry with the OK key.
3. Set the desired country setting.
NOTICE: This option infl uences the country-specifi c operating settings of
the inverter. Please consult KACO service for further information.
0 1 2 3 1
Grid type/
guideline
 If available, select the type of grid applicable to the use of the
inverter.
0 1 2 3 1 DC starting volt.
The inverter begins feed-in as soon as this PV voltage is present.
 Set the starting voltage.
0 1 2 3 1 Const. volt. ctrl
Off ers the possibility of deactivating the MPP seek mode in order to
operate the inverter with a constant DC voltage.
 Activate or deactivate MPP seek mode.
 Set value for constant voltage control (200 - 800 V).
NOTICE: The possible input power is reduced at voltages lower than
350 voltage. The input current is limited to 18.6 A per input.
0 1 2 3 0 “Information” menu
 Open the menu: Press the right arrow key or
the OK key.
0 1 2 3 1 Inverter type Displays the type designation of the inverter.
0 1 2 3 1 SW version Displays the installed software version.
0 1 2 3 1 Serial number Displays the serial number of the inverter.
0 1 2 3 1 Display country
Displays the selected country setting.
Optional: Displays the grid type if a grid type has been selected.
0 1 2 3 0 “Vendor” menu » The display shows information about the unit manufacturer.