Yaskawa SmartTrac CPU Card - Manual (Page 16)

SMART TRAC CPU Card
12
••
Testing Card Installation Technical Manual
MagneTek
Smart Trac
Starting OS
Operating System
Running
Press the MENU
Key to begin
Displayed for 2 seconds
Displayed for 0.25 second
For 0.25 second if Digital Operator
Driver installed. Otherwise,
displays continuously.
Displayed until MENU key
pressed.
Figure 3. Normal Boot Messages.
If you press the Menu key on the Digital Operator within 2 seconds of the start
of the boot process, you will access the Boot Menu, allowing you to configure
various operating parameters. These parameters include TCP/IP Configuration,
Inverter Type, COM1 Configuration, Serial Download from COM1 or Flash
Memory erasure or programming mode, a check of the firmware version, and
Flash ROM access.
NOTE: The second boot message "Starting OS" can be read as an ASCII string,
output from serial port J5.