Yaskawa Ladder Works Operation Manual - Manual (Page 67)

2.8 SAVE PROGRAM
2-50
2.8 SAVE PROGRAM
There are two methods of saving the program, Save and Save All. The program is saved in
both the hard disk on PC and the controller in on-line mode, but it is saved in only the hard disk
on PC in the off-line mode.
2.8.1 Save
An active program file is overwrote and saved.
1.
Select File (F) - Save (S) of the menu.
< Key Operation >: Ctrl+S
2.
An active program file is overwrote and saved.
2.8.2 Save All
All opened program files are overwrote and saved.
1.
Select File (F) - Save All (L) of the menu.
2.
All opened program files are overwrote and saved.