Yaskawa Ladder Works Operation Manual - Manual (Page 112)

4.3 CROSS REFERENCE
4-16
(1) Data Type
Select the symbol or the register.
(2) Symbol
Input the searched symbol name.
The symbol names can be set up to 30 at the same time.
(3) Register
Input the range of the searched register.
Ranges of the register can be set up to 30 at the same time.
(4) Program name
Input the searched program name. The wild-card (*) is available. For example, All H
program is searched when H* is input as a program name.
(5) Setting History
A set condition is selected from the history.
The set condition input in the past is memorized as the history.
The latest history becomes "History -1".
(6) Same memory searching
It is available when the register is selected. All registers which use the same memory
are searched. For example, when MW00000-MW00010 is specified, MB000000-
MB00001F, ML00000-ML00010, and MF00000-MF00010 are also searched.
(7) Case check
It is available when the symbol is selected. The upper case and lower case are
distinguished.
(8) Attribute
Set the attribute of the searched symbol or register used in the program.
(9) Execute
Execute the cross reference.
(10) Cancel
Cancel the crossing reference condition dialog.
(11) Option
Display the cross reference options.