Sybase 11.9.x-12.5 - Manual (Page 157)

CHAPTER 6 Adaptive Server Error Messages
831
1505 14 Create unique index aborted on duplicate key. Primary key is `%S_KEY'
Explanation: Refer to the writeup for this error.
1507 10 Warning: deleted duplicate row. Primary key is `%S_KEY'
Explanation: Report the error to your System Administrator. You may need to increase
swap space.
1508 14 Create index aborted on duplicate rows. Primary key is `%S_KEY'
Explanation: Refer to the writeup for this error.
1509 20 Row compare failure of RIDs (%ld, %d) and (%ld, %d), keycnt = %ld, compflags = %ld,
rowformat = %ld, minlen = %ld.
Explanation: Refer to the writeup for this error.
1510 17 Sort failed: Out of space in database `%.*s'
Explanation: Refer to the writeup for this error.
1511 20 Sort cannot be reconciled with transaction log
Explanation: Adaptive Server encountered an internal error indicative of some problem
in logging/recovery. Reconnect to Adaptive Server. Report the error to your System
Administrator.
1513 20 Reuse of extent failed in sort
Explanation: Adaptive Server encountered an internal error indicative of some problem
in logging/recovery. Reconnect to Adaptive Server. Report the error to your System
Administrator.
1514 21 Sort failed because it attempted to allocate page %ld and found that the page was busy.
Buffer %S_BUF contains a cached and referenced page with objid %ld indid %ld and
status 0x%x.
Explanation: Adaptive Server encountered an internal error affecting all processes using
the current database. Report the error to your System Administrator.
1515 20 Bad session descriptor for sort
Explanation: This error occurs during a sort operation when the server finds that a
session descriptor (pointing to row ID’s) is invalid. Shut down and restart the server to
correct the problem.
1519 20 Internal Sort Error. A transaction that is involved in Parallel Sort is being redone.
Explanation: Adaptive Server encountered an internal error affecting the current
process. Restart Adaptive Server.
1520 18 Sort failed for table `%.*s' in database `%.*s' because internal count of used pages is
incorrect. Run DBCC TABLEALLOC to correct the value.
Explanation: The create index command allocates a work area based on an estimate in
the OAM page of the number of data pages in the table. If this value is too low, the work
area is too small, the sort fails, and Error 1520 is raised. Use
dbcc tablealloc to update
the page count and correct this error.
Number Severity Text and Explanation