SMA SPEEDWIRE V.1.1 - Manual (Page 12)

4 Product Description SMA Solar Technology AG
12 SPW-WebconPB-IA-en-11 Installation Manual
Figure 2: Layout of the SMA Speedwire/Webconnect Piggy-Back
Label with PIC and RID for Registration of a Small Plant in Sunny Portal
To activate the Piggy-Back in Sunny Portal, you will need the PIC and RID numbers printed on the
supplied label. After installation of the Piggy-Back, a label should be affixed on the exterior of the
inverter in the vicinity of the type label. Keep the other label in a safe place for future reference.
4.2 Possible Network Topologies
The possible network topologies depend on the devices used and on the number of network ports.
The Speedwire/Webconnect Piggy-Back is equipped with one network port. For further information
on network topologies, refer to the Technical Information "SMA Speedwire Fieldbus" at
www.SMA-Solar.com.
4.3 Type Label
Type Label
The type label clearly identifies the Speedwire/Webconnect Piggy-Back. The type label is located on
the front panel of the Speedwire/Webconnect Piggy-Back.
Figure 3: Layout of the type label
The information on the type label is required for safe use of the Speedwire/Webconnect Piggy-Back
and for reference if customer support from the SMA Service Line is needed. The type label must be
permanently affixed to the Speedwire/Webconnect Piggy-Back.
Item Description
A Female connector
Item Explanation
A Device type
B Serial number
C Hardware version