SMA SMC 9000TL - Manual (Page 17)

SMA Solar Technology AG 4 Display
User Manual SMC9-11TLRP-BA-en-30 17
4.3 Display Messages during Operation
When the inverter is in operation, the following messages alternate on the display. Each display
message appears for five seconds, then the cycle starts again.
4.4 Display Messages during a Fault
* This display message only appears if a measured value is responsible for the fault.
• If an error message is displayed, contact your installer.
4.5 DC Overvoltage
Display message Description
Current feed-in power and voltage of the PV array
Current values for reactive power Qac and
displacement power factor cos φ (PF)
Energy produced so far and total number of hours in
feed-in operation
Energy generated on the current day and MPP status
message
Display message Description
Energy generated on the current day
(example: 0Wh) and status message
(example: Disturbance)
Operating state (example: disturbance) and
error message (example: Vac-Bfr)
Measured value at the time of the disturbance
(example: 261 V) and current measured value
(example: 245 V)*
Display message Description
The DC input voltage into the inverter is too high.
• Contact your installer immediately.