Air shutter, Operating instructions, Cara – Enviro ENVIRO User Manual

Page 7

HUTTER

Air Shutter Adjustment Nut

Figure 5: Air Shutter Adjustment.

The air shutter is controlled by

sliding the air shutter adjustment

screw (shown in Figure 5) either

forwards or backwards. The

adjustment screw, for the primary

air, is located on the bottom of the

firebox. The air shutter nut can be

accessed by removing the control

panel. This is best done during the

initial installation.
Sliding the shutter forwards

increases the primary air while

sliding the shutter backwards

decreases the primary air.
The air shutter allows the amount

of air coming into the fireplace to be

adjusted in order to accommodate

different climates and venting

arrangements. Start the pilot and

then the burner. Make sure the pilot

flame is burning normally and none

of the burner ports are plugged.

Let the fireplace burn for roughly

fifteen (15) minutes and then

examine the flames, compare the

flames to Figure 56.

Operating Instructions

For Your Safety, Read Safety Precautions

And Lighting Instructions Before Operating

Cara

On/Off

High

Low

Off

Fan

Remote Control Receiver

(optional)

Ignitor

Figure 4: Cara Control Panel.