Enviro ENVIRO - Manual (Page 10)

IMPORTANT: Ensure the unit is off and
at room temperature.
To remove the burner:
1. Remove the glass door as shown in
the M
AINTENANCE AND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
.
2. Carefully remove the log set.
3. Slide the burner back just far enough
so the front edge of the burner does
not catch on the front lip of the
firebox.
4. Lift the front of the burner up and out
of the firebox.
To install the burner:
1. Insert the mixing tube into the mixing
tube box (refer to Figure 8).
2. When the burner is resting in the
firebox ensure that the front edge of
the burner is lined up with the front
lip of the firebox (see figure 9).
3. Re-install the logset (see S
ECONDARY
I
NSTALATION
- L
OG
S
ET
I
NSTALLATION
) and
the door.
4. Check burner for proper operation.
Figure 9: Align Burner With Firebox.
Figure 8: Install the Burner to the Firebox.
10
Maintenance And Service
R
EPLACING THE
G
LASS
:
IMPORTANT: Do not operate with the glass front removed, cracked or broken. The glass in the
fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory replacement door
is required (see P
ARTS
L
IST
). Wear gloves when handling the damaged glass door assembly to prevent
personal injury. When the glass door assembly is being transported, it must be wrapped in newsprint and
tape and/or a strong plastic bag. Removal and replacement of the glass from the door must be done by
a licensed or qualified service person. The door assembly must be purchased from an ENVIRO dealer.
No substitute materials are allowed.
C
LEANING
T
HE
F
IREBOX
:
With the fireplace at room temperature, carefully remove the logs. Gently remove the ceramic burner
and place on a paper towel. Vacuum the bottom of the firebox thoroughly. Carefully clean any dust off
the logs and remove any lint from the burner and pilot. At this time, inspect the burner pan for cracking
or severe warping. If a problem is suspected, contact the dealer. Check the logs for deterioration or large
amounts of soot; a small amount on the bottom side of the logs is normal. Replace the logs as in the L
OG
S
ET
I
NSTALLATION
section.
B
URNER
R
EMOVAL
& I
NSTALLATION
: