Enviro ENVIRO - Manual (Page 34)

Secondary Installation
I
NSTALLATION OF
C
ERAMIC
F
IREBOX
L
INER
(O
PTIONAL
):
Figure 57: Steel Firebox Liners Installation.
Figure 58: Firebox Liners Installation.
34
Do not install when the unit is hot.
The firebox liner is fragile. Handle liners
with care and avoid knocking them on any
object.
The Enviro Cara comes with a Steel Firebox Liner
installed, which must be removed if a Ceramic
Firebox Liner is to be installed.
1. Remove the glass door as shown in the
M
AINTENANCE AND
S
ERVICE
- G
LASS
D
OOR
R
EMOVAL
.
2. Carefully remove the log set.
3. Slide the burner tray back just far enough so
the front edge of the burner does not catch
on the front lip of the firebox. Lift the front of
the burner up and out of the firebox.
4. Using a T-20 screwdriver, remove the left and
right Brick Panel Clips
5. Remove the Steel Firebox Liner by pulling the
left side of the panel in towards the center of
the unit then out a little. Repeat for the right
side then pull the panel completely out.
Steel Firebox Liner
Brick Panel Clip
6. Install the rear ceramic liner by placing
it against the back of the firebox. The
top of the liner has an angled edge,
the bottom does not. Note: The
Firebox Baffle must be in place for the
Firebox Liners to be installed.
7. While holding the rear ceramic liner
from falling forward, install the left
and right liners by sliding them in
against the sides of the firebox and
up to the rear liner (refer to Figure
58).
8. Attach and tighten the brick panel
clips with the screws provided. The
side liners hold the rear liner in
place.
9. Re-install the burner (see M
AINTENANCE
AND
S
ERVICE
- B
URNER
R
EMOVAL
&
I
NSTALLATION
), log set (see S
ECONDARY
I
NSTALLATION
- L
OG
S
ET
I
NSTALLATION
), and
the door.