SMA 20000TL Service Manual - Manual (Page 12)

5 Troubleshooting
5.1 Event Messages
Message Cause
Inst. code valid The entered Grid Guard code is valid. Protected parameters have
now been unlocked and you can adjust the parameters. The param-
eters will be automatically locked again after ten feed-in hours.
Self-test The self-test is in progress.
Set parameter The parameter change has been adopted.
Parameters set successfully The parameter changes were successfully adopted.
Update file OK The update file found is valid.
SD card is read Memory card is being searched for update file and the update file is
being checked.
No new update SDcard An update file that has already been used is on the memory card.
Update communication The inverter is updating the communication component.
Update main CPU The inverter is updating the inverter component.
Update RS485i module The inverter is updating the corresponding component.
Update Speedwire The inverter is updating the corresponding component.
Webconnect update The inverter is updating the corresponding component.
Upd. language table The inverter is updating the corresponding component.
Update completed The inverter has successfully completed the update.
Grid param. unchanged The selected rotary switch position is not assigned or the grid param-
eters cannot be changed.
Grid param. locked The parameters are locked and you cannot change them.
5 Troubleshooting SMA Solar Technology AG
Service Manual for Installers STP20-25TL-SG-en-11 12