ShoreLand'r LAB80TBB User Manual
Page 8
Midwest Industries, Inc.
Ida Grove, IA 51445
800.859.3028
www.shorelandr.com
0004187
Page 8
03/29/2010
RB Bunk Assembly
Locate the support arms bundle. Place one of the arms into the
factory installed mounting bracket on the rear pivot with the ends
curved up as shown. Secure in the bracket with two (2) 1/2” x 4”
carriage bolts and hex lock nuts. See Detail B, Page 2. Tighten.
Place one of the bunk assemblies on the end of the support arms
just installed. Line up the top hole in the mounting bracket with the
hole in the support arm and secure with a 1/2” x 4-1/2” hex bolts
and hex lock nuts. Tighten. Repeat on the other end of this sup-
port arm. Repeat this complete process on the other support arm.
Note that the bunk assemblies have two height adjustments. The
instructions are to install them in the lowest position to keep the
center of gravity as low as possible for towing. If required, the
bunks can be installed in the raised position for fender cleanrance
by mounting the bunk assemblies to the bunk support arms using
the lower mounting hole.