ShoreLand'r LAB80TBB - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004187
Page 5 03/29/2010
Diagram C
Actuator
Locate the actuator, and position it on the front of the tongue as
shown. Look into the back end of the actuator and locate the so-
lenoid. Note there is a wire harness coiled around the round sole-
noid. Uncoil the wire and plug it into the bullet plug on the end of
the blue wire of the tongue harness. Remove the plastic plug from
the port in the rear of the solenoid Thread the fitting on the end of
the brake line into the solenoid port from which the plastic plug was
just removed. Tighten.
Align the holes in the actuator with the holes in the tongue. Secure
the actuator to the tongue using three (3) 1/2” x 4” hex bolts and
lock nuts. Tighten.
Bend the line coming out the rear of the tongue in a smooth gradual
radius being careful not to kink the line. Bend so it can be mated
to the brake line from the side frame. Once aligned thread the side
frame brake line into the other end of the coupling. Tighten both
lines into the coupling.
SAFETY CHAINS
Mount the safety chains to the front of the tongue by placing a 1/2”
flat washer onto a 1/2” x 5” hex bolt, then insert the bolt through the
last link on one of the safety chains provided. Insert the bolt through
the hole provided in the front of the tongue as shown. Once the bolt
is completely inserted, place on the other safety chain provided.
Place on another 1/2” flat washer and secure with a 1/2” hex lock
nut. Tighten.