ShoreLand'r LAB80TBB - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004187
Page 3 03/29/2010
plug must go to the left side of the trailer and the brown and green
plug must go to the right side of the trailer.
Plug the tongue wire harness ends into the frame harnesses by
matching colors and ends. Place grommets into the wire holes.
Push the extra wire provided either into the hole in the tongue or
else remove the grommet in the side frame and place the extra wire
in the side frame. Replace grommets just removed.
Brake Line
Remove the brake line from the brake kit box 68140. Locate the 58”
tongue line. Uncoil the line and insert one end into the rear of the
tongue pushing it forward until the end comes out of the front of the
tongue. Locate the brass brake line coupling in the hardware box
and thread on the rear fitting of the brake line.
TONGUE
The tongue comes shipped separately. Locate and install under
the frames front tongue channel and in the channel welded to the
front cross member which will support the rear of the tongue.
Line the hole in the tongue with the hole in the tongue channel. In-
stall the 1/2” x 4-1/2” carriage bolt in the front cross hole and secure
with a 1/2” lock nut. Secure the rear of the tongue to the frame with
a 1/2” x 4” hex bolt and lock nut. Tighten.
Tongue Wire Harness
Locate the tongue wire harness. Place the end of the wire harness
with the two double plugs into the hole in the top of the tongue. Pull
backwards through the tongue until they can be fished through the
holes in each side of the tongue. Note that the brown and yellow