ShoreLand'r PT1720 V.1 - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004034
Page 5 Rev C 05/13/2010
the other side of the tongue.
Locate the proper length tongue. Insert the rear of the tongue into
the frame tongue channel sliding it thru until it slides into the mount-
ing channel on the second crossmember until the mounting holes
line up. Secure the tongue into the frame by placing a ½” x 4 1/4”
hex bolt in the front tongue channel and the channel on the second
crossmember. Secure both mounting bolts with ½ flange lock nuts.
Tighten.
Locate the wire harness that is in the tongue. Plug the tongue wire
harness ends into the frame harnesses by matching colors and
ends. Push the excess wire provided either into the side of the
tongue or else remove the grommet in the front crossmember and
insert the excess wire. Replace grommets just removed.
COUPLER
Locate the coupler. Drop it into position on the front of the tongue.
Secure it to the tongue using a ½” x 4” hex bolt through the rear
mounting hole of the coupler housing. Insert completely through
the tongue, then secure in place with a ½” flange lock nut.
Attach the front of the coupler to the tongue using two- ½” x 1” hex
bolts. Insert the bolt through one side of the coupler housing and
the tongue. Secure inside the tongue using a ½” flange lock nut.
Repeat this process on the other side of the tongue. Tighten all at-
taching bolts securely.