ShoreLand'r PT1720 V.1 - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004034
Page 4 Rev C 05/13/2010
Position the carpeted bunks so approximately 10” extends past
the back of the rear bunk saddle support. Attach the bunks to the
brackets using the ¼” x 1 ½” lag screws provided.
Repeat this process on the bunk on the other side of the bunk sad-
dle support and then on the other side of the trailer.
TONGUE
See Page 4 (assembly for PT1720) and Page 5 (assembly for
PT1420)
Once the proper tongue is identified place it on the stands so it can
be prepared for installation into the frame. Locate the two amber
side marker lights shipped in the hardware box. Uncoil the wire
insert the plug into the larger, center hole that is drilled in the side
of the tongue. As the wire is inserted into the hole direct the wire so
it will go to the forward end of the tongue. Pull the wire out the front
of the tongue. It will be connected to the tongue harness at a later
time. Attach the light to the tongue using two (2) No. 10 x 3/4” self
tapping screws provided. Repeat this process on the other light on