ShoreLand'r PS4X6 - Manual (Page 7)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003620
Page 7 REV D 04/15/200
Run the frame harness wires through
the hole on the to side of the tongue
when the trailer is in it’s normal upright
position. Push the wires to the rear of the
tongue and thread the wires through the
wire hole at the top side of the tongue in
it’s normal upright position. Place grom-
mets in both wire holes.
Slide the wire tube into the rear cross
channel and through the chassis. Note
theat the two pre-drilled holes on the
wire tube must be inserted in first as
shown. Thread the frame harness wires
just installed in the tongue into the wire
tube. Pull wires out the rear of the tube
so that the plugs are exposed.
Insert two (2) 1/8” x 1-1/2” cotter key
through the pre-drilled holes on the wire
tube as shown. Separate the legs of the
cotter key to secure.
Install molded grommets over the wires
to secure. Insert the wires in the hole
next to the wire tube.
Insert the side marker light wires
through the large pre-drilled hole in the
side of the tongue. Pull out the front of
the tongue. Mount the side marker light
to the tongue in the pre-drilled holes
using #10-16 X 3/4” self-drill screws as
shown.
Connect wires from the side marker
light to the plugs provided on the frame
harness - brown on brown.
Insert a 3/8” X 1-1/4 hex bolt with a 3/8”
flat washer and safety chain through the
lower hole on the front of the tongue.
Secure with a 3/8” flat washer and 3/8”
flange lock nut. Repeat procedure on
opposite side of the tongue. Loosen
and remove the rear hex nut holding
the coupler to the tongue and place the
white ground wire on the bolt threads.
Replace the nut and tighten.
Place the taillight into the light channel
with the green/brown wiring and white
grounding wire fed through the wire hole
as shown.
Notice that the left taillight has the
yellow and brown wire. Slide the taillight
into the light channel. Install the license
plate bracket over the bolts on the
taillight. Attach to the rear crossmember
and secure with the hardware provided
with the taillight.