beautypg.com

ShoreLand'r PS4X6 User Manual

Page 3

background image

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0003620

Page 3

REV D 04/15/200

Slide the tongue into the front cross

weldment and secure with hitch pin

w/clip. In the rear of the tongue insert a

1/2” X 4-1/2” hex bolt and two (2) 1/2”

nylon washers (between tongue and

mounting plates). Secure with a 1/2”

flange lock nuts.

Mount the coupler to the tongue in the

two (2) top holes of the tongue using

one (1) 1/2” X 4” hex bolt in the rear

hole. Secure with a 1/2” flange lock nut.

Secure the front of the coupler to the

tongue using two (2) 1/2” X 1” hex

bolts. Secure with 1/2” flange lock

nuts.

In the rear chassis cross weldments

insert the spring bushing spacer.

Secure the bushing to the chassis

cross weldments using 1/2” X 3-

1/4” hex bolts and 1/2” flange lock

nuts.

Slide the spring into the rear chas-

sis cross weldment under the spring

bushing just installed. Insert the eye

of the spring in the front chassis cross

weldment and secure with the two (2)

remaining 9/16” X 3-1/4” hex bolts.

Tighten with 9/16” hex nuts.

Mount the axle assembly to the springs

just installed using the 3/8” X 2-3/16” X

1-3/4” SUB and secure with 3/8” flange

lock nuts.

Mount the tires to the axle assembly us-

ing 1/2” lug nuts. Tighten to secure.

Use saw horses to aid in the assembly.

Lay the deck ( with the deck side down)

on the saw horses.

NOTE: The decals should face the

outside of the ATV trailer. Decals

closest to the front will determine the

front of the trailer.

Using a hoist or lifting device, lift your

ATV trailer off the saw horses and place

on it’s tires.

If installing the light kit, install when trail-

er is upside down on the saw horses.

Double check all fasteners and tighten

before towing.

The ATV trailer is

not highway or street

legal without the light kit being installed.

The light kit must be installed before

towing on public highways and/or

streets!

TOOLS REquIRED fOR ASSEMBLy

3/4” Wrench/Socket

3/8” Wrench/Socket

5/16” Socket (sidelights)

9/16” Wrench/Socket

7/16” Wrench/Socket

Cable/Wire (to run harness/light

wires)

7/8” Wrench/Socket

13/16” Wrench/Socket

Optional equipment and replacement

parts must be purchased through an

authorized ShoreLand’r dealer.