ShoreLand'r BK1000U V.1 - Manual (Page 7)

AMERICAN STANDARDS FOR WIRING:
YELLOW - RIGHT
GREEN - LEFT
BROWN - RUNNING
WHITE - GROUNDING
When securing the taillight and bracket to
the rear crossmember, secure the
grounding wires before tightening.
Secure the wire tube to the rear
crossmember using a conduit clamp, 1/4” X
3/4” hex bolt and 1/4” flange lock nut.
Tighten 1/4” flange lock nut to secure the
conduit clamp around the wire tube as
shown.
Insert the wire harness through the plastic
tube as shown.
Pull the wire harness through the plastic
tube as shown.
Plug wire harness in.
Place a conduit clamp around the plastic
tube.
Secure to the inside of the rear cross-
member using a 1/4” X 3/4” hex bolt and 1/
4” flange lock nut.