ShoreLand'r BK1000U V.1 - Manual (Page 5)

Secure the chasis crossmembers to
the center of the ATV trailer using 3/8”
X 1” carriage bolts and 3/8” flange
lock nuts.
The chasis assembly is shown
complete. Note that the chasis with
the tongue bolt plate are mounted
towards the front of the ATV trailer.
Slide the tongue into the front cross
weldment and secure with 1/2” X 5”
hitch pin w/lynch (Ref.#30). In the
rear of the tongue insert a 1/2” X 4-
1/2” hex bolt and two (2) 1/2” nylon
washers (between tongue and
mounting plates). Secure with a 1/2”
flange lock nut.
Mount the coupler to the tongue in the
two (2) top holes of the tongue using
one (1) 1/2” X 4” hex bolt in the rear
hole. Secure with a 1/2” flange lock
nut. Secure the front of the coupler to
the tongue using two (2) 1/2” X 1” hex
bolts. Secure with 1/2” flange lock
nuts.
In the rear chasis cross weldments
insert the spring bushing spacer
(Ref.#40). Secure the bushing to the
chasis cross weldments using 1/2 “ X
3-1/4” hex bolts and 1/2” flange lock
nuts.
Slide the spring into the rear chasis
cross weldment under the spring
bushing just installed. Insert the eye
of the spring in the front chasis cross
weldment and secure with the two (2)
remaining 9/16” X 3-1/4” hex bolts
Tighten with 9/16” hex nuts.
Mount the axle assembly to the
springs just installed using the 3/8” X
2-3/16” X 1-3/4” SUB (Ref.#18) and
secure with 3/8” flange lock nuts.
Mount the tires to the axle assembly
using 1/2” lug nuts. Tighten to secure.
Using a hoist or lifting device, lift
your ATV trailer off the saw horses
and place on it’s tires.
If installing light kit, install when
trailer is upside down on saw
horses.
Double check all fasteners and
tighten before towing.
The ATV trailer is not highway/
street legal without light kit being
installed. The light kit must be
installed before towing on public
higways and/or streets!