ShoreLand'r BK1000U V.1 - Manual (Page 4)

BK1000U Assembly Instructions
For easy assembly of your BK1000U
trailer, please follow the directions
given in order. The assembly will be
done with the ATV trailer being
upside down.
Use saw horses to aid in the assem-
bly. Remove decks from the boxes.
Lay the decks (with deck side down)
on the saw horses. NOTE: The
decals should face the outside of the
ATV trailer. Decals closest to the front
will determine the front of the trailer.
Remove the hardware bag from the
box - #65904. Sort the hardware.
Using a 3/8” X 1” hex bolt (Ref.#13)
with a 3/8” flat washer (at the head of
the bolt), secure the decks at each
end as shown. Tighten using a 3/8”
flange lock nut. Refer to to parts
drawing on page 3 for placement.
Mount the front cross weldment to the
front of the deck assembly using a 3/
8” X 3-3/4” carriage bolt (Ref.#16)
through the deck and bolt bushing
(Ref.#7). Secure with a 3/8” flange
lock nut. Repeat on other side.
Slide the front cross weldment into
the deck as shown.
Mount the rear cross channel (Ref.#3)
to the rear of the deck assembly
using two (2) 3/8” X 3-3/4” carriage
bolt through the deck and bolt
bushing. Repeat on other side.
Secure the rear channel and the front
cross weldment to the decks in the
middle using a 3/8” X 1-1/2” carriage
bolt with spacer, 3/8” flat washer, 3/8”
lock washer and 3/8” hex nut in order
given. Tighten.
Place the chasis crossmember
(Ref.#1) toward the front of the ATV
trailer and the chasis crossmember
(Ref.#2) towards the rear of the ATV
trailer. Repeat other deck as shown.
Refer to parts drawing on page 3 for
proper placement.
Secure the chasis crossmembers to
the outside of the decks using 3/8” X
3-3/4” carriage bolts down through the
deck and chasis crossmember and
tighten with 3/8” flange lock nuts.