ShoreLand'r TA0015 V.2 - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003263
REV D 04/29/2008
Page 3
Battery Box Installation Instructions
Locate the battery box mounting plate, Item No. 1 and the battery
boxes. Note that there are two battery boxes and two batteries.
They are both required to power the brake system in the event of
an unwanted disconnect from the tow vehicle.
1. Attach the two battery boxes to the mounting plate using ¼” x 1”
carriage bolts and ¼” lock nuts as shown in Diagram D. Once
all bolts are installed, tighten.
2. Place the assembly on the inside of the frame as shown in Dia-
gram A and secure to the frame using two of the appropriate
size U-bolts as described earlier in the actuator assembly in-
structions. Secure with 3/8” hex nuts w/ nylon locks. Position
the battery box assembly from the front of the frame to the front
of the mounting bracket as shown in Diagram C. Leave the u-
bolts loose so the battery boxes can be moved forward so the
battery wire harness will reach.
Batteries
1. Place the batteries in the battery boxes. Remove the protective
covers from the battery terminals. Locate the battery wire har-
Diagram D
SD Control
Module
Brakeline
Port