ShoreLand'r SLRB55TCBBS - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004293
Page 4 of 14 11/04/2010
Plug the tongue wire harness ends into the frame har-
nesses by matching colors and ends. Pushes the
extra wire provided into the rear of the tongue or
remove the grommet in the side frame and place the
extra wire in the side frame. Replace grommet just re-
moved.
BRAKE LINE
Locate the brass brake line coupling. Remove the
plastic cap and thread the brake line hose coming
out the rear of the tongue into one end of the
coupling. Bend the line in a smooth gradual
radius being careful not to kink the line. Bend so
it can be mated to the brake line hose from the
side frame. Once aligned, thread the side frame
brake line hose into the other end of the coupling.
Tighten both lines into the coupling.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a 1/2” flat washer,
then place through the last link of one of the safety chain. Insert
through the hole in the actuator housing and out the other side. Slide
the last link of the other chain over the bolt and slide on a flat washer.
Secure with a 1/2” .flange lock nut. Tighten.
Assembly is complete.