ShoreLand'r SLB82TAL - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004016
Page 9 Rev A 11/18/2008
Refer to your ShoreLand’r Owner’s
Guide and other decals on trailer for
additional information.
SAFETY INSTRUCTIONS
4810709
Proper tongue weight must be maintained.
Rev C 8/28/06
Before towing, check the following to ensure
that:
1. All parts, bolts, nuts and wheel lug nuts
are tight.
2. Tie downs, winch strap and bow-eye
safety chain are secure.
3. Tires are inflated to manufacturer’s
standards. (See tire sidewall)
4. Wheel bearings have adequate grease.
5. Trailer coupler and coupler ball are the
same size.
6. Coupler is properly attached and
secured to coupler ball.
7. Trailer safety chains are crossed under
the tongue and attached to towing
vehicle.
8. All lights are operational. Note: It is
recommended that the trailer lights be
disconnected before backing into the
water.
9. Trailer tongue jack is in up or travel
position.
10. Hitch ball has a rating that is equal to or
greater than the coupler or actuator
GVWR.
11. All wheel lug nuts must be tightened to a
minimum torque rating of 85 ft/lb.
12. Lug nuts must be re-torqued after the
first 50 miles, then periodically thereafter.
4810709 REV 8-06.ai 8/28/2006 7:29:33 AM
Winch Assembly:
Refer to page 8 for winch parts diagram.
The winch post assembly comes factory assembled and ready to
mount on the tongue. Position the winch assembly on the tongue in
a location that would best fit your watercraft. Using two (2) 1/2” X 3
9/16” X 5” stainless steel square u-bolts, secure the winch assem-
bly to the tongue. Tighten with four (4) 1/2” stainless steel lock nuts
so that the winch assembly will not slide on tongue. Set the other
mounting plate in position and secure it using two (2) 1/2” X 3 9/16”
X 5” stainless steel square u-bolts and four (4) 1/2” stainless steel
lock nuts. Refer to winch adjustments on page 16.