ShoreLand'r SLB82TAL - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0004016
Page 4 Rev A 11/18/2008
Actuator/ Safety Chain:
Mount the actuator onto the tongue (matching the hole pattern) us-
ing three (3) 1/2” X 4 1/2” stainless steel hex bolts and three (3) 1/2”
stainless steel hex lock nuts with nylon inserts. Mount the safety
chains to the front of the tongue using a 1/2” X 1-1/2” stainless
steel hex bolts, followed by a 1/2” stainless steel flat washer and
safety chain. Secure this assembly on the inside of the tongue us-
ing a 1/2” stainless steel hex lock nut with nylon insert. Repeat the
above instructions on the other side of the tongue.
Straighten the 58" brake line that is included in the brake kit box
and attach to the rear of the actuator. Route brake line thru holes in
the top of the tongue and insert grommets to protect the brake line.
Connect line to the frame line with a tube coupling and tighten.
Special caution should be taken that while assembling these
stainless steel components to use Anti-seize compound on
the threads to help prevent gauling.
Tongue:
Slide the tongue into the tongue channel weldment on front cross-
member. Secure the tongue with a 1/2” X 4 1/2” stainless steel hex
bolt, 1/2” stainless steel flat washer and 1/2” stainless steel hex
lock nut with nylon insert.
Secure the tongue to the tongue plate on the frame using two (2)
1/2” X 3 9/16” X 5” square u-bolts and four (4) 1/2” stainless steel
hex lock nut with nylon inserts.