ShoreLand'r SLB58T User Manual
Page 9
Midwest Industries, Inc.
Ida Grove, IA 51445
(800)859-3028
www.shorelandr.com
M304016
Page 9
RB Bunk Assembly
Locate the support arms bundle. Place one of the arms into
the factory installed mounting bracket on the rear pivot with
the ends curved up as shown. Secure in the bracket with two
(2) 1/2” x 4” carriage bolts and hex lock nuts. See Detail B,
Page 2. Tighten.
Place one of the bunk assemblies on the end of the support
arms just installed. Line up the top hole in the mounting
bracket with the hole in the support arm and secure with a
1/2” x 4-1/2” hex bolts and hex lock nuts. Tighten. Repeat on
the other end of this support arm. Repeat this complete
process on the other support arm.
Note that the bunk assemblies have two height adjustments.
The instructions are to install them in the lowest position to
keep the center of gravity as low as possible for towing. If
required for fender clearance, the bunks can be installed in
the raised position by mounting the bunk assemblies to the
bunk support arms using the lower mounting hole.