ShoreLand'r SLB58T - Manual (Page 10)

Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 www.shorelandr.com M304016
Page 10
Roller Arm Assembly
Locate the support arms bundle. Place one of the arms into
the factory installed mounting bracket on the rear pivot with
the ends curved up as shown. Secure in the bracket with two
(2) 1/2” x 4” carriage bolts and hex lock nuts. See Detail B.
Tighten. Place one of the roller assemblies on the end of the support
arms just installed. Line up the hole in the mounting bracket
with the hole in the support arm and secure with a 1/2” x
4-1/2” hex bolts and hex lock nuts. Tighten. Repeat on the
other end of this support arm. Repeat this complete process
on the other support arm.