ShoreLand'r SLB10 V.3 - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M308185
Page 5 of 8
Bunk Brackets and Bunks
Locate the bunk brackets. See Detail E and F. Note that the
front bunk brackets are located on the front of the cross
member while the rear bunk brackets are located on the rear
of the cross member. Choose a pair of holes for the bunk
location. Attach the bunk brackets to the cross members
using 3/8” x 1” carriage bolts, lock washers and hex nuts.
Hand tighten only because they will have to be adjusted
when the boat is placed on the trailer.
Position the bunks so that they are above the bunk brackets
just installed. Note that the mounting brackets attached to
the bunks are not centered on the bunks but are off center 4
inches. They can be installed either direction. Positioning them
so the extra bunk is to the rear will allow you to put a longer
boat on the trailer. This adjustment may also be critical when
trying to establish the correct tongue weight.
Attach the bunks to the brackets using 3/8” x 1” carriage bolts
and flange lock nuts. Tighten but do not over tighten because
the bunks must be allowed to rotate at this point so they will
conform to the boat when it is placed on the trailer.