ShoreLand'r SL80TAL - Manual (Page 11)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M311055
REV B 5/05/04 Page 11
Mount the front bunk support weldments to the pivot weldments by
placing them in the channel of the pivot weldments and attaching with
1/2” x 4-1/2” hex bolts and lock nuts. Place the bunk assembly
over the support weldment, align the holes of the bunk brackets
with the holes in the support weldment and secure using 1/2” x
1-1/2” carriage bolts and lock nuts. Tighten but do not over tight-
en because the bunks must rotate to conform to the boat bottom.
Note: The bunk pivot base weldment is adjustable on the front cross.
Loosen the 1/2” U-bolts (Ref#3, Page 14) enough to move the bunk
pivot base weldment in or out on the front cross to a location that best
conforms to your watercraft.
Front Bunk Assembly:
Front Bunk Assembly