ShoreLand'r SL80TAL - Manual (Page 10)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com M311055
REV B 5/05/04 Page 10
Mount the rear bunk support weldments to the pivot weldments by plac-
ing them in the channel of the pivot weldments and attaching with 1/2” x
4-1/2” hex bolts and lock nuts. Place the bunk assembly over the sup-
port weldment, align the holes of the bunk brackets with the holes in the
support weldment and secure using 1/2” x 1 1/2” carriage bolts and lock
nuts. Tighten but do not over tighten because the bunks must rotate to
conform to the boat bottom.
Note: The bunk pivot base weldment is adjustable on the front cross.
Loosen the 1/2” U-bolts (Ref#3, Page 14) enough to move the bunk
pivot base weldment in or out on the front cross to a location that best
conforms to your watercraft.
Rear Bunk Assembly:
Rear Bunk Assembly