HEIDENHAIN TNC 620 (81760x-01) ISO programming - Manual (Page 441)

Datum Setting with 3-D Touch Probe (Touch Probe Function
Software Option)
14.9
14
TNC 620 | User's Manual for DIN/ISO Programming | 3/2014
441
14.9 Datum Setting with 3-D Touch Probe
(Touch Probe Function Software
Option)
Overview
The following soft-key functions are available for setting the datum
on an aligned workpiece:
Soft key Function Page
Datum setting in any axis with 441
Setting a corner as datum 442
Setting a circle center as datum 444
Center line as datum
Setting the centerline as datum 446
Datum setting in any axis
To select the touch probe function, press the
PROBING POS soft key
Move the touch probe to a position near the touch
point
Use the soft keys to select the probe axis and
direction in which you want to set the datum, such
as Z in direction Z–
Start the probing procedure: Press the machine
START button
Datum: Enter the nominal coordinate and confirm
your entry with the
Set datum soft key, See
"Writing measured values from the touch probe
cycles in a datum table", page 431
Exit the probing function: Press the
END soft key.
HEIDENHAIN only gives warranty for the function of
the probing cycles if HEIDENHAIN touch probes are
used.