HEIDENHAIN TNC 620 (81760x-01) Cycle programming - Manual (Page 96)

Fixed Cycles: Tapping / Thread Milling
4.1 Fundamentals
4
96
TNC 620 | User's Manual Cycle Programming | 3/2014
4.1 Fundamentals
Overview
The TNC offers 8 cycles for all types of threading operations:
Cycle Soft key Page
206 TAPPING NEW
With a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance 97
207 TAPPING NEW
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance 100
209 TAPPING WITH CHIP BREAKING
Without a floating tap holder, with
automatic pre-positioning, 2nd set-up
clearance, chip breaking 103
262 THREAD MILLING
Cycle for milling a thread in pre-drilled
material 109
263 THREAD MILLING/
COUNTERSINKING
Cycle for milling a thread in pre-drilled
material and machining a countersunk
chamfer 113
264 THREAD DRILLING/MILLING
Cycle for drilling into solid material
with subsequent milling of the thread
with a tool 117
265 HELICAL THREAD DRILLING/
MILLING
Cycle for milling the thread into solid
material 121
267 OUTSIDE THREAD MILLING
Cycle for milling an external thread
and machining a countersunk chamfer 125