HEIDENHAIN TNC 320 (34055x-06) ISO programming User Manual
Page 29
TNC 320 | User's Manual for DIN/ISO Programming | 5/2013
29
11 Programming: Multiple Axis Machining...................................................................................... 309
11.1
Functions for multiple axis machining.............................................................................................. 310
11.2
The PLANE Function: Tilting the Working Plane (Software Option 1)............................................311
Introduction.............................................................................................................................................311
Defining the PLANE function.................................................................................................................313
Position display.......................................................................................................................................313
Resetting the PLANE function............................................................................................................... 314
Defining the working plane with the spatial angle: PLANE SPATIAL.................................................... 315
Defining the working plane with the projection angle: PLANE PROJECTED........................................ 317
Defining the working plane with the Euler angle: PLANE EULER.........................................................318
Defining the working plane with two vectors: PLANE VECTOR........................................................... 320
Defining the working plane via three points: PLANE POINTS...............................................................322
Defining the working plane via a single incremental spatial angle: PLANE SPATIAL.............................324
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function)...................................... 325
Specifying the positioning behavior of the PLANE function.................................................................. 327
11.3
Miscellaneous functions for rotary axes........................................................................................... 332
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1)............................................... 332
Shortest-path traverse of rotary axes: M126.........................................................................................333
Reducing display of a rotary axis to a value less than 360°: M94.........................................................334
Selecting tilting axes: M138...................................................................................................................335