HEIDENHAIN TNC 320 (34055x-06) ISO programming - Manual (Page 188)

Programming: Programming contours
6.5 Path contours – Polar coordinates
6
188
TNC 320 | User's Manual for DIN/ISO Programming | 5/2013
Circular path G12/G13/G15 around pole I, J
The polar coordinate radius
R is also the radius of the arc. R is
defined by the distance from the starting point to the pole
I, J. The
last programmed tool position will be the starting point of the arc.
Direction of rotation
In clockwise direction:
G12
In counterclockwise direction:
G13
Without programmed direction:
G15. The TNC traverses the
circular arc with the last programmed direction of rotation
Polar-coordinates angle H: Angular position of
the arc end point between –99 999.9999° and
+99 999.9999°
Direction of rotation DR
Example NC blocks
N180 I+25 J+25 *
N190 G11 G42 R+20 H+0 F250 M3 *
N200 G13 H+180 *
For incremental coordinates, enter the same sign for
DR and PA.
Circle G16 with tangential connection
The tool moves on a circular path, starting tangentially from a
preceding contour element.
Polar coordinate radius R: Enter the distance
from are end point to the pole
I, J
Polar coordinates angle H: Angular position of the
arc end point
The pole is not the center of the contour arc!
Example NC blocks
N120 I+40 J+35 *
N130 G01 G42 X+0 Y+35 F250 M3 *
N140 G11 R+25 H+120 *
N150 G16 R+30 H+30 *
N160 G01 Y+0 *