HEIDENHAIN TNC 320 (34055x-06) ISO programming User Manual
Page 16
Contents
16
TNC 320 | User's Manual for DIN/ISO Programming | 5/2013
2
Introduction.......................................................................................................................................61
2.1
The TNC 320........................................................................................................................................... 62
Programming: HEIDENHAIN conversational and ISO formats.................................................................62
Compatibility............................................................................................................................................. 62
2.2
Visual display unit and operating panel..............................................................................................63
Display screen.......................................................................................................................................... 63
Setting the screen layout......................................................................................................................... 64
Control Panel............................................................................................................................................ 64
2.3
Modes of Operation............................................................................................................................... 65
Manual Operation and El. Handwheel..................................................................................................... 65
Positioning with Manual Data Input.........................................................................................................65
Programming............................................................................................................................................ 65
Test Run................................................................................................................................................... 66
Program Run, Full Sequence and Program Run, Single Block................................................................. 66
2.4
Status displays....................................................................................................................................... 67
"General" status display............................................................................................................................ 67
Additional status displays......................................................................................................................... 68
2.5
Accessories: HEIDENHAIN 3-D Touch Probes and Electronic Handwheels.......................................74
3-D touch probes..................................................................................................................................... 74
HR electronic handwheels....................................................................................................................... 75