Polaris 2008 Ranger Crew - Manual (Page 91)

88
MAINTENANCE
Brakes
Brake Inspection
1. Check the brake system for
fluid leaks.
2. Check the brake pedal for
excessive travel or a spongy
feel.
3. Check the friction pads for
wear, damage and looseness.
4. Inspect the brake disc spline
and pad wear surface for
excessive wear.
5. Change pads when worn to
3/64" (1 mm).
Park Brake Inspection
1. Apply the brakes.
2. Pull the park brake lever
downward as far as possible.
3. Check the vehicle for move-
ment. The vehicle should not
roll while parked. If the vehi-
cle moves, adjust the park
brake.
Park Brake Cable Tension
Inspect and adjust park brake cable tension after the first 25 hours of
operation and every 100 hours thereafter to ensure proper cable tension.
Loss of tension in the park brake cable may cause illumination of the
park brake light and activation of the limiting feature. If this occurs,
move the park brake lever to the forward-most position, then inspect and
adjust park brake cable tension.
NOTE: If performing this service is difficult due to conditions or location, open
the hood and temporarily disconnect the park brake connector. This
will inactivate the limiting function. Reconnect the connector as soon
as possible, and adjust the park brake cable to proper tension.
1. Position the vehicle on a level surface.
2. Shift the transmission to neutral.
3. Loosen or tighten the nuts on the lever end of the park brake cable
as needed.
3/64" (1mm)
Park Brake
Release