Polaris 2007 Victory Hammer - Manual (Page 133)

128
MAINTENANCE
Sidestand
Straddle the motorcycle and bring it to a vertical position. Move the sidestand to its stored (up) position, then to its
fully extended (down) position, and back again. It should move smoothly and quietly. When the sidestand is in its
stored position, the sidestand return spring should hold the sidestand tightly against the motorcycle.
If the sidestand is bent, it should be replaced immediately.
Do not try to straighten a bent sidestand. The sidestand will be
weakened, and may not be able to support the motorcycle.
Caution
Inspect Sidestand Pad
Straddle the motorcycle and bring it to a vertical position. Move the
sidestand (1) to its stored (up) position, then to its fully extended
(down) position and back again. It should move smoothly and
quietly. When the sidestand is in its stored position, the sidestand
return spring should hold the sidestand tightly against the
motorcycle.
Check the condition of the sidestand rubber pad (2), and make sure
it’s firmly attached to the sidestand. Check the wear indicator (3) on
the leading edge of the sidestand rubber pad. Replace the pad if worn
beyond the WEAR LIMIT line on the pad.
Front of Motorcycle
Trailing Edge Leading Edge
2
1
3
1. Sidestand
2. Rubber Pad Wear
3. Wear Indicator