Maintenance – Polaris 2007 Victory Hammer User Manual

Page 132

127

MAINTENANCE

Headlamp Adjustment

The headlamp should shine straight ahead of the

motorcycle. The top of headlamp high beam should

be just below the center of the lamp at a distance of

25 feet (7.62 m). The low beam pattern spreads

farther right of center than the high beam (U.S. &

Canada).

1. Check and adjust the tire pressure (page 115)
2. Verify rear suspension ride height measurement

is 132mm (5--3/16 inch) (see page 93) before

adjusting headlight.

3. Straddle the motorcycle in an upright position

and sit in the operator’s seat.

4. Set the ignition switch to the ON position and

set the headlamp to High beam. Check the

headlamp for correct aim.

5. To adjust the headlamp vertically, loosen pivot nut (1)

while holding bolt. Aim headlight and hold in position

while tightening nut.

Torque: 35 ft-lbs (47.5 Nm)

6. To adjust the lamp horizontally, loosen the nut (2), aim

headlight and hold in position while tightening nut.

Torque: 28 ft-lbs (38 Nm)

7. Verify proper headlamp adjustment and re-adjust if

necessary.

25 feet (7.62 m)

Center of Headlamp

High Beam