Polaris 2007 Victory Hammer - Manual (Page 126)

121
MAINTENANCE
Seat Removal and Installation
The seat mounting screws are located under the three cowl grommets at the rear of the seat and are accessed from
the top after removing the seat cowl.
Always make sure the seats are securely fastened before riding the motorcycle. A loose seat could
cause a sudden shift in riding position, causing loss of control.
WARNING
Seat Removal
1. Remove the passenger seat cowl by pulling directly
upward on both sides of the cowl evenly (see arrows).
2. Remove the (3) socket head screws from each side of the
seat using a 5mm hexagonal wrench.
3. Lift the rear of the seat and pull rearward to disengage
the tab at the front of the seat.
4. Remove the seat.
Seat Installation
5. Slide the tongue of the seat into the frame’s receiver at
rear of fuel tank.
6. Align the screw holes at the rear of seat.
7. Ensure the front seat mount is engaged in the front
receiver, then install the screws and tighten to 57 in. lbs. (6.8 Nm).
8. Reinstall passenger seat cowl.
1. Remove Rear Cowl
2. Remove (3) screws. 3. Lift Rear of Seat, Pull
Rearward
1
2