Polaris 2002 ATV Sportsman 6X6 - Manual (Page 89)

86
MAINTENANCE AND LUBRICATION
Engine Cooling System
Radiator Coolant Level In-
spection
NOTE: This procedure is only
required if the cooling system
has been drained for
maintenance and/or repair.
However, if the recovery bottle
has run dry, the level in the
radiator should be inspected and
coolant added if necessary.
To access the radiator pressure cap:
Remove the four screw securing front rack. Remove front cover by
placing your fingers under the front of the cover and pulling upward.
NOTE: Use of a non-standard pressure cap will not allow the
recovery system to function properly. If the cap should need
replacement contact your dealer for the correct replacement part.
To insure that the coolant maintains its ability to protect the engine, it
is recommended that the system be completely drained every two years
and a fresh mixture of antifreeze and water be added. Polaris
recommends the use of Polaris Premium 60/40 anti-freeze/coolant or a
50/50 mixture of high quality aluminum compatible anti-freeze/coolant
and distilled water.
NOTE: Polaris Premium 60/40 is already premixed and ready to use.
Do not dilute with water.
NOTE: Always follow the manufacturer’s mixing recommendations
for the freeze protection required in your area.
Using a funnel, slowly add coolant as necessary through the radiator
filler neck.
Rack
Front
Cover
WARNING
Never remove the pressure cap when the engine is warm or hot.
Escaping steam can cause severe burns. The engine must be
cool before removing the pressure cap.