Elmo Visual Presenter HV-7100SX - Manual (Page 26)

Posi / Nega Conversion
To show a negative film.
Press the [POSI / NEGA] button on the front
operation panel or wireless remote control, the
indicator lamp lights up and the image will be
converted to the NEGA mode accordingly.
When the [POSI / NEGA] button is pressed again,
the indicator lamp goes out and the POSI mode is
resumed.
In the condition of NEGA, the followings are
restricted.
• When contrast on: Gamma adjustment is not
available.
• Only When Gamma setting γ = 07: Contrast can
be turned on.
NEGA setting at the factory
• Gamma:
γ = 07 (0.3)
• Contrast: on
• White Balance: Auto mode
PAUSE
2x
SET PRESET
LIVE
MEMORY
CALL SET IMAGE CALL
LAMP POSI/NEGA COLOR/B&W UPPER BASE
IRIS
AF NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
RGB1 RGB2 MAIN MONITOR OUTPUT
MONITOR OUTPUT PAUSE
F.A.M.
MAIN
RGB1
RGB2
IRIS OPEN CLOSE
ZOOM
TELE
WIDE POSI / NEGA IMAGE ROTATION
AUTO/MANUAL
CONTRAST
WHITE
BALANCE
LAMP
UPPER / BASE / OFF
AF
IRIS OPEN CLOSE
POSI / NEGA IMAGE ROTATION
AUTO/MANUAL
CO
W
B
LAMP
UPPER / BASE / OFF
SET PRESET CALL SET IMAGE CALL
LAMP POSI/NEGA COLOR/B&W UPPER BASE
Color / B&W Selection
To present the B&W (Black&White) material such as
documents. A clearer image can be achieved without
color blur on a monitor.
If the [COLOR/B&W] button on the wireless remote
control is pressed, images are switched.
Wireless remote control
25
1
2
3
4
5
6
7
8
9
10
11
PAUSE
2x
SET PRESET
LIVE
MEMORY
CALL SET IMAGE CALL
LAMP POSI/NEGA COLOR/B&W UPPER BASE
IRIS
AF
NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
RGB1 RGB2 MAIN MONITOR
OUTPUT
Front operation panel Wireless remote control
Front operation panel
Wireless remote control