Elmo Visual Presenter HV-7100SX - Manual (Page 19)

Simple steps for Presenting Printed Material
(1) Turn on the power switch.
Before turning on the power switch, connection to
the monitor should have been completed.
The indicator lamp (green LED) on the front panel
shows the initial status of each function.
If the power switch is turned on immediately after
being turned off, this product may not operate. For
restarting, turn off this product and wait several
seconds then turn on.
(2) Place the object on the stage. Adjust the image
size according to the object size by using the
zoom buttons ([TELE] / [WIDE]) on the front
operation panel or the zoom tele/wide buttons
([ZOOM.TELE] / [ZOOM.WIDE]) on the
wireless remote control, while watching the
image on the TV monitor.
(3) Press the auto focus button [AF] on the front
panel or the wireless remote control.
The auto focus function works up to a height of
approx. 10cm (3.9 in) above the stage surface.
PAUSE
2x
SET PRESET
LIVE
MEMORY
CALL SET IMAGE CALL
LAMP POSI/NEGA COLOR/B&W UPPER BASE
IRIS
AF NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
RGB1 RGB2 MAIN MONITOR OUTPUT
18
6
OPERATION PROCEDURES
Wireless remote control
1
2
3
4
5
6
7
8
9
10
11
Front operation panel
Front operation panel
Wireless remote control
Wireless remote control
(2)
(3)
MONITOR OUTPUT PAUSE
F.A.M.
MAIN
RGB1
RGB2
IRIS OPEN CLOSE
ZOOM
TELE
WIDE POSI / NEGA IMAGE ROTATION
AUTO/MANUAL
CONTRAST
WHITE
BALANCE
LAMP
UPPER / BASE / OFF
AF
Front operation panel
(2) (3)
ZOOM
TELE
WIDE
MANUAL
CONTRAST
WHITE
BALANCE
MP
A
AF
NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
ZOOM
WIDE CONTRAST
AF
IRIS
AF
NORMAL OPEN CLOSE