Grass Valley After Effects Plug-in Vertigo Suite v.4.9 - Manual (Page 13)

After Effects Plug-in User Manual 2-7
Miranda Animation option
VAF Export tab
The VAF Export options (figure 2-6 ) exposes a series of advanced settings which affect the
way in which the After Effects Plug-in renders VAF video clip files based upon an After
Effects project.
Figure 2-6. The VAF Export tab
The following table provides descriptions for each of the parameters on the VAF Export tab.
Same as Oxtel Export
Settings
When enabled, this parameter keeps the VAF settings the same as the
OXI/OXA settings.
Note that the loop settings between OXI/OXA and VAF are different. We
interpret them as follows:
• OXI C
YCLE = VAF Loop Entire Animation
• OXI S INGLE S HOT = VAF Single Shot
• OXI P ING P ONG = VAF Loop Entire Animation
• OXI I N L OOP O UT = Loop Range user set start frame to user set end frame
• OXI L INEAR C ONTROL = VAF Single Shot
Frame Rate (For TGA
Sequence on Disk)
The frame rate option for TGA sequences dictates the frame rate that will
be written into the video file. Since there is no way to store a frame rate with
a TGA sequence, it must be specified manually in this parameter.
Choose one of the following settings: 25, 30M, 30, 50, 60M or 60.
Looping
Loop Mode - Choose from among the following settings to specify the
animation’s loop behavior during playout.
•
Single Shot: The video is played just once through.
• Loop Entire Animation: The video plays in its entirety, then restart
from the beginning.
• Loop Range: The video plays to the End Frame as defined in the
dialog then jump back to the Start Frame and then keep looping
between these two frames.