Grass Valley TTN-BAV-0808 - Manual (Page 23)

BAV-0808 Rev. 0
15
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Repeat the last three lines for all outputs 3 – 8 too.
Step 4. - Push “F3”,
- Push “OUT1”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Push “IN3”
- Push “OUT2”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Repeat the last three lines for all outputs 3 – 8 too.
Step 5. - Push “F4”,
- Push “OUT1”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Push “A/V Toggle”, and select Audio (Red light),
- Push “IN4”
- Push “OUT2”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Repeat the last three lines for all outputs 3 – 8 too.
Step 6. - Push “F5”,
- Push “OUT1”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Push “A/V Toggle”, and select Audio (Red light),
- Push “IN5”
- Push “OUT2”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Repeat the last three lines for all outputs 3 – 8 too.
Step 7. - Push “F8”,
- Push “OUT1”,
- Push “A/V Toggle”, and select A+V (Red + Green light),
- Disconnect all inputs, i.e. No inputs are lit,
- Repeat the last three lines for all outputs 2 – 8 too.
Step 8. - Push “Panel Enable”, to save all salvos, and stop programming.
Step 9. - Push “Panel Enable” again, to enable operation of the BAV-0808 again.
This completes the programming example.