beautypg.com

Amp commands, Device management, P1/p2-remote mode, see – Grass Valley T2 Classic iDDR AMP Remote Control SP4.3 User Manual

Page 9

background image

October 17, 2011

T2 Users Manual –AMP Remote Control–

9

AMP commands

AMP commands

The AMP commands available in T2 are listed in the following tables. The commands
with

in the list are not supported by T2.

For detailed information on AMP commands, refer to the AMP Specification

document.

CAUTION: The latency in the number of frames from the time the command, such

as Play or Stop, is issued until the operation actually starts is not fixed. The video

loaded on multiple T2 cannot be synchronized in the accurate frames.

CAUTION: Clips that are not allowed to play or that contain playback restriction

are not loaded on T2.

Device management

○:

Supported

Command

Channel

-less

mode

R1

P1/P2

Normal

mode

3D

Sync

mode

Fill/Key

mode

Supplementary note on T2 operation

01.06

Set Drop
Frame Mode

"DF mode" setting that is in

Miscellaneous

in the "General" tree from

Config

.

will be

changed.
Since "DF mode" is a common setting for R1/
P1/P2, the setting change will be applied to
other channels.

00.0C

Local
Disable

No

Enabling and disabling of local control or
remote control can be set for each channel.

0X.1D

Local
Enable

No

Enabling and disabling of local control or
remote control can be set for each channel.

00.11

Device Type
Request

0x20 and 0x50 are returned corresponding to
the device category and the model number,
respectively.

20.04 Standby Off

No

No

No

No

No

20.05 Standby On

No

No

No

No

No

20.60 EE Off

No

No

No

No

20.61 EE On

No

No

No

No

21.62

Set Mute
Mode

No

No

It takes several seconds from the time the
command has been issued until the setting is
applied.

A8.20

Set Device
ID

A0.21

Device ID
Request

A0.2C

Device
Name
Request