Grass Valley T2 Classic iDDR AMP Remote Control SP4.3 - Manual (Page 3)

October 17, 2011 T2 Users Manual –AMP Remote Control– 3
Introduction
Introduction
This manual describes AMP command control on T2 SP4.
Overview
For T2, the following operations are available with AMP command via Ethernet.
• "External device control from T2 (R1-VTR mode)" on page 3
• "T2 Control from external device (R1-Remote mode)" on page 5
• "T2 Control from external device (P1/P2-Remote mode)" on page 7
CAUTION: The AMP commands for T2 do not support operation via RS-422.
For the available AMP commands, see the description in the following section.
• "AMP commands" on page 9
Additional functions of T2 SP4
The additional functions of T2 SP4 are as follows:
• Control with AMP commands from our product Kayak HD
• Playback of playlists with AMP commands
• Acquisition of playlist information with AMP commands (using In Preset,
Preview In Preset, List First ID, List Next ID commands)
• Export of clips and playlists with AMP commands
External device control from T2 (R1-VTR mode)
R1-VTR mode controls an external device (VTR) using T2 as the controller (master).
When T2 orders recording operation between In and Out points, the VTR records the
specified range.
If you use AMP commands in the R1-VTR mode, connect T2 and VTR via Ethernet,
and then configure T2 by the following procedure.
Configuration for using AMP commands
This section describes the procedure in which a user operates T2 in the workstation
mode. The same procedure applies to the operation in the front panel mode.